HP ProCurve 7102dl Reference Manual page 751

SROS Command Line Interface Reference Guide
ip address <address> <mask> [secondary]
Use the ip address command to define an IP address on the specified interface. Use the optional
secondary keyword to define a secondary IP address. Use the no form of this command to remove a
configured IP address.
Syntax Description
<address>
<mask>
secondary
Default Values
By default, there are no assigned IP addresses.
Functional Notes
Use secondary IP addresses to allow dual subnets on a single interface (when you need more IP
addresses than the primary subnet can provide). When using secondary IP addresses, avoid routing loops
by verifying that all devices on the network segment are configured with secondary IP addresses on the
secondary subnet.
Usage Examples
The following example configures a secondary IP address of 192.168.72.101/30:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#ip address 192.168.72.101 255.255.255.252 secondary
To view configured secondary IP address(es), use the show running-config command. Secondary IP
address information is not available through other show commands.
5991-2114
Defines the IP address for the interface in dotted decimal notation (for example:
192.168.73.101).
Specifies the subnet mask that corresponds to the listed IP address.
Optional. Defines a secondary IP address for the specified interface.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
749