SROS Command Line Interface Reference Guide
show tcp info [realtime] <control block>
Use the show tcp info command to display TCP control block information in the SROS. This information
is for troubleshooting and debug purposes only. For more detailed information, you can optionally specify
a particular TCP control block. When a particular TCP control block is specified, the system provides
additional information regarding crypto map settings that the show tcp info command does not display.
Syntax Description
realtime
<control block>
Default Values
No default value necessary for this command.
Functional Notes
Use the realtime argument for this command to display full-screen output in real-time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit reatime
mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the information
will truncate at the bottom of the screen. In order to maximize the amount of data displayed, increase the
terminal length (using the terminal length command; refer to
Usage Examples
The following is a sample from the show tcp info command:
ProCurve>enable
ProCurve#show tcp info
TCP TCB Entries
ID STATE
LSTATE OSTATE TYPE
0
FREE
FREE
1
LISTEN FREE
2
LISTEN FREE
3
LISTEN FREE
4
LISTEN FREE
5
FREE
FREE
etc.
5991-2114
Displays full-screen output in real-time. See the Functional Notes below for more
information.
Optional. Specify a particular TCP control block for more detailed information.
FLAGS
FREE
SRVR
0
FREE
CONN
0
FREE
CONN
0
FREE
CONN
0
FREE
CONN
0
FREE
SRVR
0
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
terminal length <lines>
RPORT
LPORT
SWIN SRT INTERFACE
0
0
0
0
21
0
0
80
0
0
23
0
0
5761
0
0
0
0
on page 294).
0
NONE
0
NONE
0
NONE
0
NONE
0
NONE
0
NONE
282