HP ProCurve 7102dl Reference Manual page 102

SROS Command Line Interface Reference Guide
debug ip bgp [events | in | out | keepalives | updates | updates quiet]
Use the debug ip bgp command to activate debug messages associated with IP BGP. Debug messages are
displayed (real-time) on the terminal (or Telnet) screen. Use the no form of this command to disable the
debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
events
in/out
keepalives
updates
updates quiet
Default Values
By default, all debug messages in the SROS are disabled.
Functional Notes
If no arguments are given, the debug ip bgp command displays general BGP events such as
sent/received message summaries, route processing actions, and results. Keepalive packets are not
debugged with this command.
Usage Examples
The following example enables debug messages on general outbound BGP messages and events:
ProCurve#debug ip bgp out
07:42:39: BGP OUT 10.15.240.1[2]: Transmitting msg, type=UPDATE (2), len=142
5991-2114
Displays significant BGP events such as a neighbor state change.
Displays the same information as debug ip bgp, but limits messages to the
specified direction (in or out).
Displays BGP keepalive packets.
Displays BGP updates for all neighbors.
Displays summary information about BGP neighbor updates. (Note: updates
quiet displays a one-line summary of what update displays in 104 lines.)
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
100