SROS Command Line Interface Reference Guide
ip pim-sparse propagation-delay <time>
Use the ip pim-sparse propagation-delay command to specify the expected propagation delay for
join/prune messages. Set the propagation delay (in milliseconds) to estimate the amount of delay found in
the local link. Use the no form of this command to return to the default value.
Syntax Description
<time>
Default Values
By default, the propagation-delay is set to 500 milliseconds.
Usage Examples
The following example sets the expected propagation delay to 300 milliseconds on the ATM interface 1.1:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm1.1)#ip pim-sparse propagation-delay 300
5991-2114
Specifies the expected propagation delay in the local link in milliseconds. Valid
range is 0 to 32,767 milliseconds.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
765