HP ProCurve 7102dl Reference Manual page 638

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set
ip dhcp renew
Use the ip dhcp renew command to transmit a message to the DHCP server requesting renewal of the IP
address lease on that interface.
Default Values
No defaults necessary for this command.
Functional Notes
Dynamic Host Configuration Protocol (DHCP) allows interfaces to acquire a dynamically assigned IP
address from a configured DHCP server on the network. Many Internet Service Providers (ISPs) require
the use of DHCP when connecting to their services. Using DHCP reduces the number of dedicated IP
addresses the ISP must obtain.
Usage Examples
The following example renews the IP address assigned (by DHCP) on the Ethernet interface (eth 0/1):
ProCurve(config)#int eth 0/1
ProCurve(config-eth 0/1)#ip dhcp renew
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 636