HP ProCurve 7102dl Reference Manual page 893

SROS Command Line Interface Reference Guide
frame-relay multilink [ack <seconds> | bandwidth-class <class>
<threshold> | bid <string> | hello <seconds> | retry <number>]
Use the frame-relay multilink command to enable the Frame Relay multilink interface. When the no
form of this command is issued, all configuration options associated with this command and binds made to
this interface are removed.
Syntax Description
ack <seconds>
bandwidth-class
<class>
<threshold>
bid <string>
hello <seconds>
retry <number>
Default Values
The default ack value is 4 seconds. The default hello value is 10 seconds. The default <class> value is a.
The default retry value is 2.
Functional Note
This command is different from ppp multilink. In ppp multilink, if multiple binds are configured for the
PPP interface without multilink PPP being enabled, the first link to bring up LCP will be the only link to
actually bind. In Frame Relay multilink, since there is no protocol corresponding to LCP, all binds will be
removed and the user will be free to re-issue any bind.
5991-2114
Optional. Specifies a wait for acknowledgement time (in seconds) for every
bundle link in the bundle. Range: 1 to 180 seconds.
Optional. Specifies the class of operation, placing a minimum limit on the
acceptable amount of bandwidth required for a bundle to initialize.
Optional. Specifies the class of operation. Range: a to c.
Class A A single active link is sufficient for the bundle to be up.
Class B All defined bundle links must be active for the bundle to be up.
Class C A minimum threshold of links must be active for the bundle to be up.
Optional. Specifies the minimum number of active bundle links required for a
Class C bundle to be in the up state. This option will not be available unless
Class C is specified. Range: 1 to 65,535 links.
Optional. Specifies a bundle ID (up to 48 characters) for the multilink bundle. All
hello messages sent on links belonging to the multilink bundle contain the bundle
ID. By default, the SROS creates a generic bundle ID for each configured multilink
bundle using the following: MFR<interface number> where the interface number
corresponds to the interface number of the frame relay interface. For example, if
multilink is enabled on frame-relay interface 1, by default the bundle ID is MFR1.
Changing the bundle ID causes the multilink connection to go down for
renegotiation.
Optional. Specifies the time (in seconds) between hello messages for every
bundle link in the bundle. Range: 1 to 180 seconds.
Optional. Specifies the number of times a bundle link will retransmit a message
while waiting for acknowledgement. Range: 1 to 5 times.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Frame Relay Interface Config Command Set
891