HP ProCurve 7102dl Reference Manual page 961

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set
lldp send-and-receive
Use the lldp send-and-receive command to configure this interface to transmit and receive LLDP packets.
Syntax Description
No subcommands.
Default Values
By default, all interfaces are configured to transmit and receive LLDP packets of all types.
Functional Notes
Individual LLDP information can be enabled or disabled using the various forms of the lldp send
command. For example, use the lldp send-and-receive command to enable transmit and receive of all
LLDP information. Then use the no lldp send port-description command to prevent LLDP from
transmitting port description information.
Usage Examples
The following example configures the Frame Relay sub-interface (fr 1.16) to transmit and receive LLDP
packets containing all information types:
ProCurve(config)#interface frame-relay 1.16
ProCurve(config-fr 1.16)#lldp send-and-receive
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 959