HP ProCurve 7102dl Reference Manual page 739

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
<value> Enter bandwidth in kbps.
Default Values
To view default values, use the show interfaces command.
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets bandwidth of the ATM sub-interface to 10 Mbps:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#bandwidth 10000
5991-2114 © Copyright 2006 Hewlett-Packard Development Company, L.P. 737