Test-Call [Dial <Number> | Speed <56 | 64> | Answer | Hangup | Hangup Channels <1 | 2>] - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
test-call [dial <number> | speed <56 | 64> | answer | hangup | hangup
channels <1 | 2>]
Use the test-call command to dial, answer, or disconnect a test call used for verifying the BRI interface
connection. No data traffic is permitted on an ISDN interface in test mode.
Syntax Description
dial <number>
speed <56 | 64>
answer
hangup
hangup channels <1 | 2>
Default Values
By default, test call functionality is disabled.
Usage Examples
The following example places the bri 1/1 interface in test answer mode and then removes the interface
from test answer mode:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#test-call answer
ProCurve(config-bri 1/2)#no test-call answer
5991-2114
Places the interface in test mode and makes an outbound call to the
entered number. Enter the number to dial using numerical digits without
spaces or special characters (such as hyphens or parentheses). Test
calls made using the test-call dial command will perform channel
negotiation, but no data passes through from end to end on the call.
Remove the interface from test mode using the no test-call dial
command.
Specifies a channel rate of 56 or 64 kbps for the test call.
Places the interface in test answer mode and configures it to accept
inbound calls. Using the test-call answer command supersedes any
other interface configuration that may exist. Test calls answered by the
interface while in test mode will perform channel negotiation, but no
data passes through from end to end on the call. Remove the interface
from test answer mode using the no test-call answer command.
Disconnects all active test calls.
Disconnects the active test call on the specified B channel (B1 or B2).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
590