Enable Mode Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
E M
NABLE ODE
To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password
has been configured, a password prompt will display.) For example:
ProCurve>enable
Password: XXXXXXX
ProCurve#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the section listed below:
exit on page 1437
ping <address> on page 1438
show running-config
All other commands for this command set are described in this section in alphabetical order.
autosynch on page 22
clear commands begin on page 24
clock [auto-correct-dst | no-auto-correct-dst]
clock set <time> <day> <month> <year>
clock timezone <text>
configure on page 66
copy commands begin on page 67
debug commands begin on page 80
dir [ * ] on page 147
dir [cflash | flash] [ * ]
disable on page 149
enable on page 150
erase on page 151
erase file-system cflash
events on page 153
exception report generate
logout on page 156
reload [cancel | in <delay>]
show commands begin on page 158
sip check-sync on page 292
telnet <address> on page 293
terminal length <lines>
5991-2114
C S
OMMAND ET
on page 1440
on page 63
on page 64
on page 148
on page 152
on page 154
on page 157
on page 294
© Copyright 2007 Hewlett-Packard Development Company, L.P.
on page 62

Enable Mode Command Set

20