SROS Command Line Interface Reference Guide
debug arp
Use the debug arp command to activate debug messages associated with IP Address Resolution Protocol
(ARP) transactions. Debug messages are displayed (real-time) on the terminal (or Telnet) screen. Use the
no form of this command to disable the debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example activates debug messages associated with ARP transactions:
ProCurve>enable
ProCurve#debug arp
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
82