HP ProCurve 7102dl Reference Manual page 874

SROS Command Line Interface Reference Guide
ppp pap sent-username <username> password <password>
Use the ppp pap sent-username/password command to configure a username and password when the
peer requires PAP PPP authentication. Use the no form of this command to remove a configured password.
For more information on PAP and CHAP functionality, refer to the Technology Review section for the
command ppp authentication [chap | pap] on page 865.
Syntax Description
<username>
<password>
Default Values
By default, there is no defined ppp pap sent-username and password.
Usage Examples
The following example specifies a PPP PAP sent-username of local and a password of my_password:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#ppp pap sent-username local password my_password
5991-2114
Specifies a username by alphanumeric string up to 80 characters in length (the
username is case-sensitive).
Specifies a password by alphanumeric string up to 80 characters in length (the
password is case-sensitive).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Demand Interface Configuration Command Set
872