SROS Command Line Interface Reference Guide
remote-alarm [rai]
The remote-alarm command selects the alarm signaling type to be sent when a loss of frame is detected
on the T1 receive signal. Use the no form of this command to disable all transmitted alarms.
Syntax Description
rai
Default Values
The default for this command is rai.
Usage Examples
The following example enables transmission of RAI in response to a loss of frame:
ProCurve(config)#interface t1 1/1
ProCurve(config-t1 1/1)#remote-alarm rai
5991-2114
Specifies sending a remote alarm indication (RAI) in response to a loss of frame.
Also prevents a received RAI from causing a change in interface operational
status.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
T1 Interface Configuration Command Set
708