HP ProCurve 7102dl Reference Manual page 471

SROS Command Line Interface Reference Guide
logging email exception-report address-list <email address>; <email
address>
Use the logging email exception-report address-list command to specify one or more email addresses to
receive an exception report for use in troubleshooting. Use the no form of this command to remove a listed
address.
Syntax Description
<email address>
Default Values
By default, there are no configured logging email addresses.
Functional Notes
When the SROS experiences an exception it will generate a file with detailed information that Technical
Support can use to diagnose the problem, This command allows the unit to email the exception report to a
list of addresses upon rebooting after the exception. This command should be used in conjunction with the
other logging email commands. Refer to
on page 468 , logging email on
warning] on page 471,
auth-password <password>]
source-interface <interface>
Usage Examples
The following example will enable exception report forwarding to john.doe@company.com using the
1.1.1.1 SMTP email server:
ProCurve(config)#logging email on
ProCurve(config)#logging email receiver-ip 1.1.1.1
ProCurve(config)#logging email exception-report address-list john.doe@company.com
5991-2114
Specifies the complete email address to use when sending exception reports.
(This field allows up to 256 characters.) Enter as many email addresses as
desired, placing a semi-colon (;) between addresses.
logging email address-list <email address> ; <email address>
on page 470 , logging email priority-level [error | fatal | info | notice |
logging email receiver-ip <ip address> [auth-username <username> |
on page 472 , logging email sender
on page 474 for more information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
on page 473, and logging email
469