SROS Command Line Interface Reference Guide
debug spanning-tree bpdu [receive | transmit | all]
Use the debug spanning-tree bpdu command to display BPDU (bridge protocol data unit) debug
messages. When enabled, a debug message is displayed for each BPDU packet that is transmitted or
received by the unit. Debug messages are displayed (real-time) on the terminal (or Telnet) screen. Use the
no form of this command to disable the debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
receive
transmit
all
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example displays debug messages for BPDU packets that are transmitted and received by
the unit:
ProCurve>enable
ProCurve#debug spanning-tree bpdu all
5991-2114
Displays debug messages for BPDU packets received by the unit.
Displays debug messages for BPDU packets transmitted by the unit.
Displays debug messages for BPDU packets that are transmitted and received by
the unit.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
142