SROS Command Line Interface Reference Guide
E1 Interface Configuration Command Set
remote-loopback
Use the remote-loopback command to configure the interface to accept loopback requests initiated by a
remote unit (or the service provider). Use the no form of this command to disable this feature.
Syntax Description
No subcommands.
Default Values
By default, all interfaces respond to remote loopbacks.
Functional Notes
This controls the acceptance of any remote loopback requests. When enabled, remote loopbacks are
detected and cause a loopback to be applied. When disabled, remote loopbacks are ignored.
Usage Examples
The following example enables remote loopbacks on the E1 interface:
ProCurve(config)#interface e1 1/1
ProCurve(config-e1 1/1)#remote-loopback
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
609