HP ProCurve 7102dl Reference Manual page 368

SROS Command Line Interface Reference Guide
interface frame-relay <label> point-to-point
Use the interface frame-relay command to create a virtual Frame Relay interface (or sublink, if specified)
that is identified using the entered number label. In addition, entering this command activates the Frame
Relay interface command set. The point-to-point keyword (optional) can be used to identify the Frame
Relay endpoint as a point-to-point link (versus multipoint). Use the no form of this command to delete a
configured virtual Frame Relay interface.
To specify a virtual Frame Relay sub-interface, the following syntax applies:
interface frame-relay <label>.<sublink label>
Syntax Description
<label>
<sublink label>
point-to-point
Default Values
By default, there are no configured virtual Frame Relay interfaces or sublinks.
Functional Notes
Creating an endpoint that uses a layer 2 protocol (such as Frame Relay) is generally a four-step process:
Step 1:
Create the Frame Relay virtual endpoint (using the interface frame-relay command) and set the signaling
method (using the frame-relay lmi-type command). Also included in the Frame Relay virtual endpoint are
all the applicable Frame Relay timers, logging thresholds, encapsulation types, etc. Generally, most Frame
Relay virtual interface parameters should be left at their default state. You must activate the interface
(using the no shutdown command) before the interface is able to pass any data. For example, the
following creates a Frame Relay interface labeled 7, sets the signaling method to ansi, and activates the
interface:
ProCurve(config)#interface frame-relay 7
ProCurve(config-fr 7)#frame-relay lmi-type ansi
ProCurve(config-fr 7)#no shutdown
Step 2:
Create the sub-interface and configure the PVC parameters. Using the sub-interface commands, apply
access policies to the interface, create bridging interfaces, configure backup, assign an IP address, and
set the PVC data-link control identifier (DLCI). For example, the following creates a Frame Relay
sub-interface labeled 22, sets the DLCI to 30, and assigns an IP address of 10.44.69.1/30 to the interface.
ProCurve(config-fr 7)#interface fr 7.22
5991-2114
Specifies the numerical virtual Frame Relay interface identifying label (valid
range: 1 to 1024)
Numerical label for the virtual sublink (valid range: 1-1007)
Optional. Identifies the Frame Relay interface as a point-to-point link (versus
multilink) By default, all created Frame Relay interfaces are point-to-point.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
366