Speed <Rate - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
speed <rate>
Use the speed command to specify the data rate for the
terminal emulator or emulator software. Use the no form of this command to restore the default value.
Syntax Description
<rate>
Default Values
By default, the speed is set to 9600 bps.
Usage Examples
The following example configures the Console port for 19200 bps:
ProCurve(config)#line console 0
ProCurve(config-con 0)#speed 19200
5991-2114
Specifies rate of data transfer on the interface (2400; 4800; 9600; 19,200; 38,400;
57,600; or 115,200 bps).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Line (Console) Interface Config Command Set
port. This setting must match your VT100
Console
548