T1 Interface Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
T1 I
NTERFACE
To activate the T1 Interface Configuration mode, enter the interface t1 command at the Global
Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface t1 1/1
ProCurve(config-t1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through]
coding [ami | b8zs]
fdl [ansi | att | none]
framing [d4 | esf] on page 703
lbo [long <-22.5, -15, -7.5, 0> | short <0-655>]
loopback commands
remote-alarm [rai]
remote-loopback on page 709
snmp trap line-status
snmp trap link-status
tdm-group <group number> timeslots <1-24> speed [56 | 64]
test-pattern [clear | errors | insert | ones | p215 | p220 | p511 | qrss | zeros]
5991-2114
C
ONFIGURATION
on page 1434
on page 700
on page 701
on page 702
begin on page 705
on page 708
on page 710
on page 711
© Copyright 2006 Hewlett-Packard Development Company, L.P.

T1 Interface Configuration Command Set

C S
OMMAND ET
on page 704
on page 712
on page 1431
on page 713
699