HP ProCurve 7102dl Reference Manual page 504

SROS Command Line Interface Reference Guide
snmp-server contact
Use the snmp-server contact command to specify SNMP server contact information. Use the no form of
this command to remove a configured contact. Variations of this command include:
snmp-server contact email <address>
snmp-server contact pager <number>
snmp-server contact phone <number>
snmp-server contact <"string">
Syntax Description
email
pager
phone
<number>
Default Values
No default values necessary for this command.
Usage Examples
The following example specifies 5551212 for the pager number:
ProCurve(config)#snmp-server contact pager 5551212
5991-2114
Specifies email address for the SNMP server contact.
Specifies pager number for the SNMP server contact.
Specifies phone number for the SNMP server contact.
Identifies the contact (up to 32 characters in length).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
502