Demand Interface Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
D I
EMAND NTERFACE
To activate the Demand Interface Configuration mode, enter the interface demand command at the
Global Configuration mode prompt. For example:
ProCurve#configure terminal
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
bandwidth <value>
called-number <DNIS number>
caller-number <CLID number>
connect-mode [answer | originate | either]
connect-order [last-successful | round-robin | sequential]
connect-sequence on page 825
connect-sequence attempts <value>
connect-sequence interface-recovery [retry-interval <seconds> | max-retries <value>]
page 827
crypto map <mapname>
demand-hold-queue <packets> timeout <seconds>
dynamic-dns on page 831
fair-queue <threshold>
5991-2114
C
ONFIGURATION
on page 1434
on page 819
on page 820
on page 821
on page 822
on page 826
on page 828
on page 833
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Demand Interface Configuration Command Set

C
OMMAND
on page 823
on page 824
on page 830
S
ET
on page 1431
on
817