SROS Command Line Interface Reference Guide
vlan-id <vlan id> [native]
Use the vlan-id command to set a VLAN ID for the Ethernet interface. Use the no form of this command
to remove an entry.
Syntax Description
<vlan id >
native
Default Values
By default, no VLAN ID is set.
Usage Examples
The following example configures a native VLAN of 5 for the Ethernet interface 0/1:
ProCurve(config)#interface eth 0/1
ProCurve(config-eth 0/1)#vlan-id 5 native
5991-2114
Specifies a valid VLAN interface ID number (1 to 4095).
Optional. Specifies that data for that VLAN ID goes out untagged. If native is not
specified, data for that VLAN ID goes out tagged.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Ethernet Interface Configuration Command Set
677