HP ProCurve 7102dl Reference Manual page 839

SROS Command Line Interface Reference Guide
ip access-group <listname> [in | out]
Use the ip access-group command to create an access list to be used for packets transmitted on or received
from the specified interface. Use the no form of this command to disable this type of control.
Syntax Description
<listname>
in
out
Default Values
By default, these commands are disabled.
Functional Notes
When this command is enabled, the IP destination address of each packet must be validated before being
passed through. If the packet is not acceptable per these settings, it is dropped.
Usage Examples
The following example sets up the router to only allow Telnet traffic into the demand interface:
ProCurve(config)#ip access-list extended TelnetOnly
ProCurve(config-ext-nacl)#permit tcp any any eq telnet
ProCurve(config-ext-nacl)#interface demand 1
ProCurve(config-demand 1)#ip access-group TelnetOnly in
5991-2114
Indicates the assigned IP access list name.
Enables access control on packets received on the specified interface.
Enables access control on packets transmitted on the specified interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Demand Interface Configuration Command Set
837