SROS Command Line Interface Reference Guide
show qos map
The show qos map command outputs information about the QoS map. This information differs based on
how a particular map entry is defined. Variations of this command include the following:
show qos map
show qos map <map name>
show qos map <map name> <sequence number>
show qos map interface <interface ID>
Syntax Description
<map name>
<sequence number>
interface <interface ID>
Default Values
No defaults necessary for this command.
Usage Example
ProCurve#show qos map
qos map priority
map entry 10
match IP packets with a precedence value of 6
priority bandwidth: 400 (kilobits/sec) burst: default
packets matched by map: 125520
map entry 20
match ACL icmp
packets matched by map: 99
map entry 30
match RTP packets on even destination ports between 16000 and 17000
packets matched by map: 0
map entry 50
match ACL tcp
packets matched by map: 4326
map entry 60
match IP packets with a dscp value of 2
set dscp value to 6
packets matched by map: 0
map entry 70
5991-2114
Enter the name of a defined QoS map.
Enter one of the map's defined sequence numbers.
Displays QoS map information for a specific interface (e.g., Frame Relay,
PPP, or ATM). Enter the show qos map interface ? command for a complete
list of interfaces.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
258