HP ProCurve 7102dl Reference Manual page 624

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set
bridge-group <group#>
Use the bridge-group command to assign an interface to the specified bridge group. Use the no form of
this command to remove the interface from the bridge group.
Syntax Description
<group#> Specifies the bridge group number (1 to 255).
Default Values
By default, there are no configured bridge groups.
Functional Notes
A bridged network can provide excellent traffic management to reduce collisions and limit the amount of
bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can
be bridged (e.g., Ethernet to T1 bridge, Ethernet to Frame Relay sub-interface).
Usage Examples
The following example assigns the Ethernet interface to bridge-group 17:
ProCurve(config)#interface eth 0/1
ProCurve(config-eth 0/1)#bridge-group 17
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 622