HP ProCurve 7102dl Reference Manual page 87

SROS Command Line Interface Reference Guide
debug atm packet
Use the debug atm packet command to activate debug messages associated with packets on ATM ports
and virtual circuits. Debug messages are displayed (real-time) to the terminal (or Telnet) screen. Use the
no form of this command to disable the debug messages. Variations of this command include the
following:
debug atm packet
debug atm packet interface atm <port id>
debug atm packet interface atm <port id> vcd <vcd number>
debug atm packet vc <VPI/VCI>
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
interface atm <port id>
vc <VPI/VCI>
vcd <vcd number>
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example activates debug ATM packet debug messages on ATM port 1:
ProCurve>enable
ProCurve#debug atm packet interface atm 1
5991-2114
Shows packets on a specific ATM port and on all virtual circuits.
Shows packets on a specific virtual circuit identified by the virtual path
identifier and virtual channel identifier (VPI/VCI).
Shows packets on specific virtual circuit descriptors (VCD).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
85