Basic Mode Command Set - HP ProCurve 7102dl Reference Manual
Secure router sros command line interface
Hide thumbs
Also See for ProCurve 7102dl:
- Configuration manual (1114 pages) ,
- Product end-of-life disassembly instructions (2 pages) ,
- Advanced management and configuration manual (1005 pages)
Table of Contents
Advertisement
SROS Command Line Interface Reference Guide
B
M
C
ASIC
ODE
To activate the Basic mode, simply log in to the unit. After connecting the unit to a VT100 terminal (or
terminal emulator) and activating a terminal session, the following prompt displays:
ProCurve>
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit
on page 1437
ping <address>
on page 1438
All other commands for this command set are described in this section in alphabetical order.
enable
on page 13
logout
on page 14
show clock
on page 15
show snmp
on page 16
show version
on page 17
telnet <address>
on page 18
traceroute <address>
5991-2114
S
OMMAND
ET
on page 19
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Basic Mode Command Set
12
Advertisement
Chapters
Table of Contents
