HP ProCurve 7102dl Reference Manual page 466

SROS Command Line Interface Reference Guide
line [console | telnet | ssh] <line-number> <ending number>
Use the line command to enter the line configuration for the specified console or telnet session. See the
sections Line (Console) Interface Config Command Set on page 534, Line (Telnet) Interface Config
Command Set on page 550, and Line (SSH) Interface Config Command Set on page 561 for information on
the subcommands.
Syntax Description
console
telnet
ssh
<line-number>
<ending number>
Default Values
By default, the SROS line console parameters are configured as follows:
Data Rate: 9600
Data bits: 8
Stop bits:1
Parity Bits:0
No flow control
By default, there are no configured Telnet sessions.
Usage Examples
The following example begins the configuration for the CONSOLE port located on the rear of the unit:
ProCurve(config)#line console 0
ProCurve(config-con0)#
5991-2114
Specifies the DB-9 (female) CONSOLE port located on the rear panel of the unit. See
Line (Console) Interface Config Command Set
the sections
information on the subcommands found in this.
Specifies a Telnet session(s) to configure for remote access. See the section
(Telnet) Interface Config Command Set
subcommands found in this.
Enters the configuration mode for SSH. Refer to the section
Config Command Set on page 561 for information on the subcommands found in
that command set.
Specifies the starting session to configure for remote access (valid range for
console: 0; valid range for Telnet and SSH: 0 to 4).
If configuring a single Telnet or SSH session, enter the session number and leave
the <ending number> field blank.
Optional. Specifies the last Telnet or SSH session to configure for remote access
(valid range: 0 to 4).
For example, to configure all available Telnet sessions, enter line telnet 0 4.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
on page 550 for information on the
on page 534 for
Line
Line (SSH) Interface
464