HP ProCurve 7102dl Reference Manual page 365

SROS Command Line Interface Reference Guide
interface <port-type> <slot/port>
Activates the Interface Configuration mode for the listed physical interface.
Syntax Description
<port-type>
<slot/port>
Default Values
No default values required for this command.
Usage Examples
The following example enters the serial interface for a serial module installed in slot 1:
ProCurve(config)#interface serial 1/1
ProCurve(config-ser 1/1)#
5991-2114
Identifies the physical port type of the installed Interface Module, Backup Module
or Ethernet port. Type interface ? for a complete list of valid interfaces.
Specifies an interface based on its physical location (slot and port). For example,
if you have a T1/DSX-1 installed in Slot 1 of an SROS product:
• The WAN-T1 port would be specified in the CLI as t1 1/1.
• The DSX-1 port would be specified as t1 1/2.
• If (for example) a backup module is also installed, then the backup port would
be specified as bri 1/3.
• If you are specifying a port that is built into the base unit (e.g., the Ethernet
port), the slot number is 0. For example, the Ethernet (LAN) port would be
specified as ethernet 0/1.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
363