HP ProCurve 7102dl Reference Manual page 917

Secure router sros command line interface

Hide thumbs Also See for ProCurve 7102dl:

Table of Contents

SROS Command Line Interface Reference Guide

backup restore-delay <seconds>

Use the backup restore-delay command to configure the amount of time the router will wait after the

network is restored before disconnecting the backup link and reverting to the primary. This setting is used

to prevent disconnecting the backup link if the primary link is "bouncing" in and out of alarm. For more

detailed information on Frame Relay backup functionality, refer to the Functional Notes section of the

command backup call-mode <role> on page 904.

Syntax Description

Default Values

By default, backup restore-delay is set to 10 seconds.

Usage Examples

The following example configures the SROS to wait 30 seconds before disconnecting backup operation

and restoring the primary connection for this endpoint:

ProCurve(config)#interface frame-relay 1.1

ProCurve(config-fr 1.1)#backup restore-delay 30

Specifies the number of seconds the SROS will wait (after a primary link is

restored) before disconnecting backup operation. Range: 10 to 86,400.

Frame Relay Sub-Interface Config Command Set

Chapters

Table of Contents