SROS Command Line Interface Reference Guide
Ethernet Interface Configuration Command Set
spanning-tree edgeport
Use the spanning-tree edgeport command to configure the interface to be an edgeport. This command
overrides the related Global setting. Use the no version of the command to return to the default setting.
Syntax Description
No subcommands.
Default Values
By default, this setting is disabled.
Functional Notes
Enabling this command configures the interface to go to a forwarding state when the link goes up.
Usage Examples
The following example configures the interface to be an edgeport:
ProCurve(config)#interface eth 0/1
ProCurve(config-eth 0/1)#spanning-tree edgeport
An individual interface can be configured to not be considered an edgeport. For example:
ProCurve(config)#interface ethernet 0/1
ProCurve(config-eth 0/1)#spanning-tree edgeport disable
or
ProCurve(config)#interface ethernet 0/1
ProCurve(config-eth 0/1)#no spanning-tree edgeport
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
672