HP ProCurve 7102dl Reference Manual page 765

SROS Command Line Interface Reference Guide
ip pim-sparse nbr-timeout <time>
Use the ip pim-sparse nbr-timeout command to specify the interval the PIM interface waits before
declaring that the neighbor is not present. Use the no form of this command to return to the default value.
Syntax Description
<time>
Default Values
By default, the nbr-timeout is set to 105 seconds.
Usage Examples
The following example specifies a wait interval of 360 seconds on the ATM interface 1.1:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#ip pim-sparse nbr-timeout 360
5991-2114
Specifies the time interval (in seconds) the PIM interface waits before a neighbor
is considered not present. Valid range is 30 to 10,800 seconds.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
763