HP ProCurve 7102dl Reference Manual page 48

SROS Command Line Interface Reference Guide
clear ip route [** | <ip address> <subnet mask>]
Use the clear ip route command to remove all learned routes from the IP route table. Static and connected
routes are not cleared by this command.
Syntax Description
**
<ip address>
<subnet mask>
Default Values
No default value necessary for this command.
Usage Examples
The following example removes all learned routes from the route table:
ProCurve>enable
ProCurve#clear ip route **
5991-2114
Deletes all destination routes.
Specifies the IP address of the destination routes to be deleted.
Specifies the subnet mask of the destination routes to be deleted
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
46