Atm Interface Config Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
ATM I
NTERFACE
To activate the ATM Interface Configuration mode, enter the interface atm command at the Global
Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface atm 1
ProCurve(config-atm 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
snmp trap on page 715
snmp trap link-status
5991-2114
C C
ONFIG OMMAND
on page 1434
on page 716
© Copyright 2006 Hewlett-Packard Development Company, L.P.

ATM Interface Config Command Set

S
ET
on page 1431
714