SROS Command Line Interface Reference Guide
Enable Mode Command Set
The following example copies the current running-configuration file to compact flash memory and names
the file config_01.txt:
ProCurve>enable
ProCurve#copy running-config cflash config_01.txt
Percent Compete 100%
ProCurve#
The following example copies the current running-configuration file to a TFTP server and names the file
config_01.txt:
ProCurve>enable
ProCurve#copy running-config tftp
Address of remote host?10.200.2.4
Destination filename config_01.txt
Initiating TFTP transfer...
Sent 3099 bytes.
Transfer Complete!
The following example copies the current running-configuration to the connected terminal using XMODEM
protocol:
ProCurve>enable
ProCurve#copy running-config xmodem
Begin the Xmodem transfer now...
Press CTRL+X twice to cancel
CCCCCC
The SROS is now ready to transmit the file on the CONSOLE port (using the XMODEM protocol). The next
step in the process may differ depending on the type of terminal emulation software you are using. For
HyperTerminal, you will now select Transfer > Receive File and select the destination. Once the transfer
is complete, information similar to the following is displayed:
Sent 3704 bytes.
Transfer complete
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
75