HP ProCurve 7102dl Reference Manual page 790

SROS Command Line Interface Reference Guide
access-policy <name>
Use the access-policy command to assign a specified access policy for the inbound traffic on an interface.
Use the no form of this command to remove an access policy association.
Note Configured access policies will only be active if the ip firewall command has been entered
at the Global Configuration mode prompt to enable the SROS security features. All
configuration parameters are valid, but no security data processing will be attempted
unless the security features are enabled.
Syntax Description
<policyname>
Default Values
By default, there are no configured access policies associated with an interface.
Functional Notes
To assign an access policy to an interface, enter the interface configuration mode for the desired interface
and enter access policy <policy name>. For more details on creating and using access policies, refer to
ip policy-class <policyname>
Usage Examples
The following example associates the access policy Private (to allow inbound traffic to the Web server) to
BVI interface 1:
Enable the SROS security features:
ProCurve(config)#ip firewall
Associate the access policy with BVI interface 1:
ProCurve(config)#interface bvi 1
ProCurve(config-bvi 1)#access-policy Private
5991-2114
Identifies the configured access policy by alphanumeric descriptor (all access
policy descriptors are case-sensitive).
on page 426.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BVI Interface Config Command Set
788