Invert Txclock - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide Serial Interface Configuration Command Set

invert txclock

Use the invert txclock command to configure the serial interface to invert the transmit clock (found in the
transmitted data stream) before sending the signal. Use the no form of this command to return to the
default value.
Syntax Description
No subcommands.
Default Values
By default, the serial interface does not invert transmit clock (txclock).
Functional Notes
If the serial interface cable is long, causing a phase shift in the data, the transmit clock can be inverted
(using the invert txclock command). This switches the phase of the clock, which compensates for a long
cable. If the transmit clock of the connected device is inverted, use the invert rxclock command to
configure the receiving interface appropriately.
Usage Examples
The following example configures the serial interface to invert the transmit clock:
ProCurve(config)#interface serial 1/1
ProCurve(config-ser 1/1)#invert txclock
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 690