HP ProCurve 7102dl Reference Manual page 875

SROS Command Line Interface Reference Guide
qos-policy [in | out] <mapname>
Use the qos-policy out command to apply a previously-configured QoS map to an interface. Use the no
form of this command to remove the map from the interface.
Syntax Description
<mapname>
in
out
Default Values
No default value is necessary for this command.
Usage Examples
The following example applies the QoS map VOICEMAP to the demand 1 interface:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#qos-policy out VOICEMAP
5991-2114
Specifies the name of a previously-created QoS map (refer to
<mapname><sequence number>
Assigns a QoS map to this interface's input.
Assigns a QoS map to this interface's output.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Demand Interface Configuration Command Set
on page 486 for more information).
qos map
873