HP ProCurve 7102dl Reference Manual page 446

SROS Command Line Interface Reference Guide
ip sip [database local | location] <username> <ip address> <port> [tcp |
udp] <number>
Use the ip sip database local command to store the location database of SIP User Agents (UAs) across a
power loss. Use the ip sip location command to manually add a SIP UA to the location database. For more
details on SIP operation, refer to the Technology Review section of the command ip firewall alg [ftp | h323
| h323 timeout | pptp | sip] on page 399. Use the no form of the ip sip location command to remove a
specific database location entry.
Syntax Description
database local
location
<username>
<ip address>
<port>
tcp
udp
<number>
Default Values
By default, this command is disabled.
Usage Examples
The following example specifies an IP SIP location of 192.33.5.99 for a user named 2001:
ProCurve(config)#ip sip location 2001 192.33.5.99
5991-2114
Stores the SIP location database using memory on the local router. This database
is maintained across a power loss.
Adds a SIP UA to the location database. Manually adding a UA to the database is
generally not required unless your SIP network is running in non-registering
mode.
Specifies the username for the UA being added to the location database.
Specifies the IP address for the UA being added to the location database.
Specifies the port of the UA to add to the database.
Specifies the use of Transmission Control Protocol (TCP) for session
communication.
Specifies the use of User Datagram Protocol (UDP) for session communication.
Specifies the time in seconds that a user is stored in the database.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
444