HP ProCurve 7102dl Reference Manual page 299

SROS Command Line Interface Reference Guide Enable Mode Command Set
wall <message>
Use the wall command to send messages to all users currently logged in to the SROS unit.
Syntax Description
No subcommands.
Default Values
No defaults necessary for this command.
Usage Examples
The following example sends the message "Reboot in 5 minutes if no objections" to the CLI screen of
everyone currently connected:
ProCurve>enable
ProCurve#wall Reboot in 5 minutes if no objections
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 297