HP ProCurve 7102dl Reference Manual page 476

SROS Command Line Interface Reference Guide
logging email source-interface <interface>
Use the logging email source-interface command to use the specified interface's IP address as the source
IP address for email messages transmitted by the unit. Use the no form of this command if you do not wish
to override the normal source IP address.
Syntax Description
<interface>
Default Values
No default value is necessary for this command.
Functional Notes
This command allows you to override the sender field in the IP packet. If you have multiple interfaces in
your unit, changing the sender tells the receiver where to send replies. This functionality can also be used
to allow packets to get through firewalls that would normally block the flow.
Usage Examples
The following example configures the unit to use the loopback 1 interface as the source IP for email
messages:
ProCurve(config)#logging email source-interface loopback 1
5991-2114
Specifies the interface to be used as the source IP address for email messages.
Type logging email source-interface ? for a list of valid interface types.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
474