HP ProCurve 7102dl Reference Manual page 877

SROS Command Line Interface Reference Guide Demand Interface Configuration Command Set
snmp trap link-status
Use the snmp trap link-status command to control the Simple Network Management Protocol (SNMP)
variable ifLinkUpDownTrapEnable (RFC2863) to enable (or disable) the interface to send SNMP traps
when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the ifLinkUpDownTrapEnable OID is enabled for all interfaces except virtual Frame Relay
interfaces.
Functional Notes
The snmp trap link-status command is used to control the RFC2863 ifLinkUpDownTrapEnable OID (OID
number 1.3.6.1.2.1.31.1.1.1.14.0).
Usage Examples
The following example disables the link-status trap on the virtual demand interface:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#no snmp trap link-status
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 875