SROS Command Line Interface Reference Guide
show demand
Use the show demand command to display information regarding demand routing parameters and
statistics. Variations of this command include the following:
show demand
show demand interface
show demand interface <interface>
show demand resource pool
show demand resource pool <resource pool name>
show demand sessions
Syntax Description
interface
interface <interface>
resource pool
resource pool <resource pool name> Displays resource pool information for a specific resource pool
sessions
Default Values
No default value necessary for this command.
Usage Examples
The following is example output from the show demand interface command:
ProCurve>enable
ProCurve#show demand int 1
Demand 1 is UP (connected)
Configuration:
Keep-alive is set (10 sec.)
Admin MTU = 1500
Mode: Either, 1 dial entries, idleTime = 120, fastIdle = 20
Resource pool demand
No authentication configured
IP address 10.100.0.2 255.255.255.0
Connect Sequence: Successes = 0, Failures = 0
Seq
DialString Technology Successes Busys NoAnswers NoAuths InUse
5
5552222
5991-2114
Displays the information for all demand routing interfaces.
Displays information for a specific demand routing interface. Valid
range: 1 to 1024. Type show demand interface ? for a list of valid
interfaces.
Displays all resource pool information.
name.
Displays active demand sessions.
ISDN
0
0
0
© Copyright 2007 Hewlett-Packard Development Company, L.P.
0
Enable Mode Command Set
178