HP ProCurve 7102dl Reference Manual page 238

SROS Command Line Interface Reference Guide
show ip processes stack
Use the show ip processes stack command to display usage information for currently running system
tasks. This command should be used when troubleshooting with ProCurve support.
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Usage Examples
The following is a sample output from the show ip processes stack:
ProCurve#show ip processes stack
Id Task
0 Idle
1 PC Config
2 Timer-00
3 Nm01
4 Clock
5 Front Panel
... etc.
5991-2114
Usage
0/8192
2723/6000
117/2048
79/2048
161/2000
195/2000
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
236