HP ProCurve 7102dl Reference Manual page 115

Secure router sros command line interface

Hide thumbs Also See for ProCurve 7102dl:

Table of Contents

SROS Command Line Interface Reference Guide

debug ip packet [detail | dump | <accesslist>]

Use the debug ip packet command to display debug messages associated with protocol-independent

multicast (PIM) sparse assert transactions. Debug messages are displayed (real-time) to the terminal (or

Telnet) screen. Use the no form of this command to disable debug messages. Variations of this command

include the following:

debug ip packet

debug ip packet detail

debug ip packet dump

debug ip packet <accesslist>

debug ip packet <accesslist> detail

debug ip packet <accesslist> dump

Turning on a large amount of debug information can adversely affect the performance of

Syntax Description

Default Values

By default, all debug messages in the SROS are disabled.

Optional. Displays IP packet detailed information.

Optional. Displays IP packet detailed information on the console or Telnet

terminal session.

Note: The console stream can be captured to a log file and used as an input

file for display with ETHEREAL by using text2pcap.exe, which is a part of

the ETHEREAL distribution.

Execute as follows: text2pcap -l 101 <input_file> <output_file>

Next, open the output file with ETHEREAL for display and decode. The

typical lower layer information in ETHEREAL may not be present. This

converted capture file is treated as a raw IP capture and also has no

timestamp data. Remember to take advantage of access control lists

(ACLs) to narrow down the amount of data being processed with this facility.

This is a CPU intensive operation and also disables any fast flow/fast cache

Optional. Enter the access-list name.

Enable Mode Command Set

Chapters

Table of Contents