Procurve(Config)#Interface Bri 1/2; Bonding Commands Begin - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
bonding txadd-timer <seconds>
Use the bonding txadd-timer command to specify the value (in seconds) for the aggregate call connect
timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds>
Default Values
By default, the bonding txadd-timer value is set to 50 seconds.
Functional Notes
Specifies the length of time both endpoints wait for additional calls to be connected at the end of
negotiation before deciding that the bonding call has failed. The factory default setting is sufficient for most
calls to connect, although when dialing overseas it may be necessary to lengthen this timer to allow for
slower call routing.
Usage Examples
The following example defines a bonding txadd-timer value of 95 seconds:

ProCurve(config)#interface bri 1/2

ProCurve(config-bri 1/2)#bonding txadd-timer 95
5991-2114
Specifies the number of seconds the endpoint will wait for additional channels (to
add to the bonded aggregate) before considering the bonding negotiation a
failure.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
576