E1 Interface Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
E1 I
NTERFACE
To activate the E1 Interface Configuration mode, enter the interface e1 command (and specify the E1
port) at the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface e1 1/1
ProCurve(config-e1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through]
coding [ami | hdb3]
framing [crc4] on page 604
loop-alarm-detect on page 605
loopback network [line | payload]
loopback remote v54
remote-alarm [rai | ais]
remote-loopback on page 609
sa4tx-bit [0 | 1] on page 610
snmp trap line-status
snmp trap link-status
tdm-group <group number> timeslots <1-31> speed [56 | 64]
test-pattern [clear | errors | insert | ones | p215 | p220 | p511 | qrss | zeros]
ts16 on page 615
5991-2114
C
ONFIGURATION
on page 1434
on page 602
on page 603
on page 606
on page 607
on page 608
on page 611
on page 612
© Copyright 2007 Hewlett-Packard Development Company, L.P.

E1 Interface Configuration Command Set

C S
OMMAND ET
on page 613
on page 1431
on page 614
601