SROS Command Line Interface Reference Guide
coding [ami | b8zs]
Use the coding command to configure the line coding for a T1 physical interface. This setting must match
the line coding supplied on the circuit by the service provider.
Syntax Description
ami
b8zs
Default Values
By default, all T1 interfaces are configured with B8ZS line coding.
Functional Notes
The line coding configured in the unit must match the line coding of the T1 circuit. A mismatch will result in
line errors (e.g., BPVs).
Usage Examples
The following example configures the T1 interface for AMI line coding:
ProCurve(config)#interface t1 1/1
ProCurve(config-t1 1/1)#coding ami
5991-2114
Configures the line coding for alternate mark inversion (AMI).
Configures the line coding for bipolar eight zero substitution (B8ZS).
© Copyright 2006 Hewlett-Packard Development Company, L.P.
T1 Interface Configuration Command Set
701