HP ProCurve 7102dl Reference Manual page 275

SROS Command Line Interface Reference Guide
show snmp
Use the show snmp command to display the system Simple Network Management Protocol (SNMP)
parameters and current status of SNMP communications. Variations of this command include the
following:
show snmp engineID
show snmp group
show snmp user
Syntax Description
engineID
group
user
Default Values
No default value necessary for this command.
Usage Examples
The following is an example output using the show snmp command for a system with SNMP disabled and
the default Chassis and Contact parameters:
ProCurve> show snmp
Chassis: Chassis ID
Contact Name:
Contact Phone:
Contact Email:
Contact Pager:
Management URL:
Management URL Label:
0 Rx SNMP packets
0 Bad community names
0 Bad community uses
0 Bad versions
0 Silent drops
0 Proxy drops
0 ASN parse errors
5991-2114
Displays the hex string that defines the current local engine ID settings.
Displays the list of all groups entered.
Displays the list of all users entered.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
273