HP ProCurve 7102dl Reference Manual page 617

Secure router sros command line interface

Hide thumbs Also See for ProCurve 7102dl:

Table of Contents

SROS Command Line Interface Reference Guide

E1 Interface Configuration Command Set

Use the ts16 command to enable timeslot 16 multiframe to be checked on the receive signal. Use the no

form of this command to disable timeslot 16.

Syntax Description

No subcommands.

Default Values

No defaults necessary for this command.

Functional Notes

If timeslot 16 is used on the incoming E1, do not map timeslot 16 using the tdm-group command. By

default, all timeslots not physically mapped using the tdm-group command are passed through to the

G.703 interface. Leaving timeslot 16 unmapped makes it available for multiframe signaling by the

connected E1 device.

Usage Examples

The following example enables timeslot 16 multiframing:

ProCurve(config)#interface e1 1/1

ProCurve(config-e1 1/1)#ts16

Chapters

Table of Contents